Palm Pilot, Palm III, V, VII, VIIx, Handera interface port pinout

PDA connectors and cables

Pin	Signal	Description
1	DTR	non-standart implementation of DTR. As long as the transceiver is enabled this pin outputs an asserted signal. 3.0 volts when transceiver shutdown (normal mode), 6.0 volts when transceiver enabled (Hotsync)
2	Vbat, +3.3v	normally connected to HotSync (pin 7) with button
3	RxD	GPS T
4	RTS
5	TxD	GPS R
6	CTS
7	HotSync IRQ	link to 3.3v (pin 2) for HotSync. Interrupt line for waking up device (initiate HotSync process in PalmOS).
8	ID	Palm modem connect this pin to 3.3v (pin 2) by 20Kohm link
9	N/C*	DC In in Palm III (+5VDC)
10	GND	GPS -

*Palm V does not contain an internal charging circuit.

Maximum transmission rate is 115200 bps (57600 bps for modem).

Here is Palm Serial cable scheme

9 pin D-SUB female connector

Pinouts.ru > PDA, HandHeld computers ports pinouts > Pinout of Palm Pilot, Palm III, V, VII, VIIx, Handera interface port and layout of 10 pin PALM special connector and 9 pin D-SUB female connector	Document status:	correct
Source(s) of this and additional information: kolumbus.fi	3 reports
Last updated at Wed Aug 15 2007. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
15831 hits since March 4, 2005