Cisco RJ45 RollOver cable pinout

network cable scheme

You can identify a roll-over cable by comparing the two modular ends of the cable. Holding the cables side-by-side, with the tab at the back, the wire connected to the pin on the outside of the left plug should be the same color as the wire connected to the pin on the outside of the right plug. If your cable was purchased from Cisco Systems, pin 1 will be white on one connector, and pin 8 will be white on the other.

Router Pin name	Router Pin	Workstation Pin	Workstation Pin name
White-Orange	1	8	Brown
Orange	2	7	White-Brown
White-Green	3	6	Green
Blue	4	5	White-Blue
White-Blue	5	4	Blue
Green	6	3	White-Green
White-Brown	7	2	Orange
Brown	8	1	White-Orange

8 pin RJ45 (8P8C) male connector

Pinouts.ru > Network cables schematic pinouts listing > Pinout of Cisco RJ45 RollOver cable and layout of 8 pin RJ45 (8P8C) male connector and 8 pin RJ45 (8P8C) male connector	Document status:	correct
Source(s) of this and additional information: Cisco Systems, Inc. and Technick.net	11 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
32408 hits since March 4, 2005