Ethernet 10Base-T crossover cable pinout |
network cable scheme |
This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX
8 pin RJ45 (8P8C) male connector |
Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair. (Just as the table above shows). Note 2: You could also connect 4-4, 5-5, 7-7, 8-8. | 8 pin RJ45 (8P8C) male connector | ||||||||||||||||||||
Pinouts.ru > Network cables schematic pinouts listing > Pinout of Ethernet 10Base-T crossover cable and layout of 8 pin RJ45 (8P8C) male connector and 8 pin RJ45 (8P8C) male connector |
correct | |
Source(s) of this and additional information: Hardware Book, Jason D. Pero , Oscar Fernandez Sierra, Jeffrey R. Broido, Patrick Smart | 5 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |