Ethernet 100Base-T4 crossover cable pinout |
network cable scheme |
This cable can be used to connect two computers together without a hub, or to connect two hubs together (without using an uplink port). If you´re connecting two hubs together and one of them has an uplink port, use a straight cable.
8 pin RJ45 (8P8C) male connector |
Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair etc. (Just as the table above shows). | 8 pin RJ45 (8P8C) male connector | ||||||||||||||||||||||||||||||||||||
Pinouts.ru > Network cables schematic pinouts listing > Pinout of Ethernet 100Base-T4 crossover cable and layout of 8 pin RJ45 (8P8C) male connector and 8 pin RJ45 (8P8C) male connector |
correct | |
Source(s) of this and additional information: Hardware Book, Kim Scholte | 20 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |