|
Ethernet 1000Base-T (Gigabit ethernet) |
������ ��������� ���� |
1000 Base-T uses all pairs for bidirectional traffic in the RJ45 connector. cables used should be of Category 5e(nhanced), even though Category 5 cables usually works too.
1000BASE-T (also known as IEEE 802.3ab) is a standard for gigabit Ethernet over copper wiring. It requires, at least Category 5 cable (the same as 100BASE-TX), but Category 5e ("Category 5 enhanced") or Category 6 cable may also be used and are often recommended. 1000BASE-T requires all four pairs to be present and is far less tolerant of poorly installed wiring than 100BASE-TX.
Each network segment cable length may be up to 100 meters, although several chip manufacturers claim 150 meters. Autonegotiation is a requirement for using 1000BASE-T, according to the standard. Several device drivers will allow you to force 1000 Mbps full duplex to eliminate autonegotiation issues. |  8 pin RJ45 (8P8C) male connector | ||||||||||||||||||||||||||||
Pinouts.ru > ���������� ��� ��������� ����� > ���������� Ethernet 1000Base-T (Gigabit ethernet) ������������� ������ 8 pin RJ45 (8P8C) female � ������ 8 pin RJ45 (8P8C) male | ������ ���������: | |
| ��������(�) � �������������� ����������: IEEE Std 802.3, 2000 Edition | 6 ������� | |
Last updated at Sat May 12 2007 (�������� ��� ����� ��� ������ ����������) | ���� �������� �������� ������ ��� �� ����������? | |
