CSU/DSU Network, T1, Fractional T1, T3 line RJ-48 pinout |
network connector |
used to connect a Bridge or Router to a 56K, CSU/DSU Network, T1, T3
8 pin RJ45 (8P8C) male connector | The RJ-48 connector look very similar to a RJ-45 connector drawn. But it's different. RJ-48 connections are made with a STP (Shielded Twisted Pair) cable (not UTP - Unshielded Twisted Pair). RJ-48 uses a pin out arrangement, voltage level, and line capacitance different from a typical RJ-45.
Cable for conection of WAN port with wall outlet is shielded (STP) straightforward (R to R, T to T) with R with T, R1 with T1 wires twisted.
| 8 pin RJ45 (8P8C) female connector | |||||||||||||||||||||||||||||||||||||||||||||||||||||||
Pinouts.ru > Network hardware interfaces pinouts listing > Pinout of CSU/DSU Network, T1, Fractional T1, T3 line RJ-48 and layout of 8 pin RJ45 (8P8C) male connector and 8 pin RJ45 (8P8C) female connector |
may be incorrect | |
Source(s) of this and additional information: Bytepile.com | 2 reports | |
Last updated at Sun May 13 2007. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |