Acer N30, N35, N310, N311, N50 pinout comments |
User opinion | Comment | Approved? |
---|---|---|
CORRECT | YES | |
CORRECT | YES | |
CORRECT | Super!!! | YES |
CORRECT | YES | |
CORRECT | YES | |
INCORRECT | pin 1,2 25,26 = +5v | YES |
CORRECT | YES | |
CORRECT | I've tested the RS232 interface specified in the diagram, connecting it to the ELMscan peripheral. (The ELMscan is a serial "scan tool" for OBD - automotive On Board Diagnosis). | YES |
CORRECT | YES | |
INCORRECT | Pin 1 ist mit Pin 26 vertauscht | YES |
CORRECT | At least charger and USB-host works well on Acer N311 | YES |
CORRECT | YES | |
CORRECT | Correct for serial port. I managed to connect Tx, Rx, Gnd, 5V to my GPS Y-junction cable. | YES |
CORRECT | all the pins are right. | YES |
ERROR FIXED | correct about the pins when PDA is client, but incorrect about the USB HOST connection | YES |
CORRECT | Hi, Thanks for your [url=http://pinouts.ru/PDA/acer_n30_pinout.shtml] Acer N 3xx pinout[/url]. Ive opened my N311 cradle, and checked your information: On the cradle PCB, the numbering of pins is the inversed to yours (1--26 and 26--1, but only a convention problem-pinout is globally correct). Pins 4(GND) and 23(+5V) are also connected to power supplies in the cradle, and are connected in the N311. To be able to make the serial output to work alone, I had to connect RTS and CTS in the cradle. It proves that the ACER N311 has a serial RS232 port (not so much known...). USB Host wiring is the same in my cradle. Its used for connecting USB devices (USB memories, hard disks...), not a computer. I havent been able to make the external speaker connections work. (Pin20=5V out ???, 2122=???). NB: you should add N300 in the title, its a generic name for N310 and N311, and is displayed in front of the pda. For the USB +5V pins (USB cable pinout), one should use 18,19 OR 23,24,25,26, depending on the power source (USB port OR 2amps charger) | YES |
CORRECT | I connect Acer N311 pin 1, 7, 11 to the serial cable Gnd I/O pin. Using software MyToken 4.2.1. Can communicated to the vehicle diagnostic controller. Very good!! | YES |
There is no audio on pins 21/22, Ive tested them, and no signal here. I also ask to an Acer technician, he give me the pinout for n30, no audio on pins 21 and 22. | YES | |
CORRECT | RS232 pins is correct | YES |