Commodore datasette pinout

connector or cable wiring scheme

      1  2  3  4  5  6
      =  =  =  =  =  =
     ###### ###########    (At the computer)
      =  =  =  =  =  =
      A  B  C  D  E  F

Pin	Description
A or 1	GND
B or 2	+5v
C or 3	Motor (computer controlled +6v for datasette motor)
D or 4	Read line from casette
E or 5	Write line cassette
F or 6	Cassette Switch Sense (monitors cassette play/ff/rew buttons)

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Pinouts.ru > Disk drives connectors pinouts listing > Pinout of Commodore datasette and layout of connector	Document status:	correct
Source(s) of this and additional information: Commodore PET FAQ, from Hardware Book	1 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
6825 hits since March 4, 2005