Mitsumi CD-ROM pinout

connector or cable wiring scheme

40 pin IDC male connector
at the controller & CD-ROM

Pin	Name	Description
1	A0	Address Bit 0
2	GND	Ground
3	A1	Address Bit 1
4	GND	Ground
5	n/c	Not connected
6	GND	Ground
7	n/c	Not connected
8	GND	Ground
9	n/c	Not connected
10	GND	Ground
11	n/c	Not connected
12	GND	Ground
13	INT	Interrupt
14	GND	Ground
15	REQ	Data request For DMA
16	GND	Ground
17	ACK	Data Acknowledge For DMA
18	GND	Ground
19	RE	Read Enable
20	GND	Ground
21	WE	Write Enable
22	GND	Ground
23	EN	Bus Enable
24	GND	Ground
25	DB0	Data Bit 0
26	GND	Ground
27	DB1	Data Bit 1
28	GND	Ground
29	DB2	Data Bit 2
30	GND	Ground
31	DB3	Data Bit 3
32	GND	Ground
33	DB4	Data Bit 4
34	GND	Ground
35	DB5	Data Bit 5
36	GND	Ground
37	DB6	Data Bit 6
38	GND	Ground
39	DB7	Data Bit 7
40	GND	Ground

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

40 pin IDC female connector
at the cable

Pinouts.ru > Disk drives connectors pinouts listing > Pinout of Mitsumi CD-ROM and layout of 40 pin IDC male connector and 40 pin IDC female connector	Document status:	unknown
Source(s) of this and additional information: SoundFX 16-bit Multimedia Kit Hardware Manual from Reveal; Keith Solomon	0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
12613 hits since March 4, 2005