Hardware pinouts information and cables schemes

Apple IIe I/O slot pinout

bus or interface

bookmark this page

UNKNOWN connector
at the computer, looking at the apple from the front


Something
Pin
Name Direction Description
1 GND  
2 DMA IN  
3 INT IN  
4 /NMI -?-  
5 /IRQ -?-  
6 /RES -?-  
7 /INH -?-  
8 -12V -?-  
9 -5V -?-  
10 NC  
11 7M -?-  
12 Q3 -?-  
13 CLK1 -?- Clock 1
14 USER 1 -?-  
15 CLK0 Clock 0
16 /DEVSEL low means port is active
17 D7 Data Lines
18 D6  
19 D5  
20 D4  
21 D3  
22 D2  
23 D1  
24 D0  
25 +12V  
26 +5V  
27 DMA OUT  
28 INT OUT  
29 /DMA -?-  
30 RDY -?-  
31 /STROBE -?-  
32 NC  
33 R/W high:Reading Data+Add. low:Writing Data+Add.
34 A15 Address Lines
35 A14  
36 A13  
37 A12  
38 A11  
39 A10  
40 A9  
41 A8  
42 A7  
43 A6  
44 A5  
45 A4  
46 A3  
47 A2  
48 A1  
49 A0  
50 I/O SEL -?-  


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > Buses and slots connectors pinouts >  Pinout of Apple IIe I/O slot and layout of connector
Document status: unknown
Source(s) of this and additional information: The Apple Connection Book
Contributor: Adam Guilmet
0 reports
Last updated at Fri Aug 19 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
6867 hits since August 13, 2005