EIA/TIA-562 serial interface pinout

serial interface

TIA/EIA-562 is an electrical only standard. It's not complete standard and intended to be referenced by complete standards, such as TIA/EIA-561. No pinout available. TIA/EIA-562 standard defines an unbalanced, unidirectional, point-to-point interface, with support of inter-operability with TIA/EIA-232-F devices.

Driver Loaded Output Voltage (Min. Level) ≥ | 3.3V |
Driver Open Circuit Output Voltage ≤ | 13.2V |
Driver Loaded Output Voltage (3 kΩ) ≥ | 3.7V |
Driver Short Circuit Current ≤ | 60 mA |
Driver Transition Time Controlled
Maximum Driver Slew Rate ≤ 30 V/μs
Driver Output Resistance (Power Off) ≥ 300Ω
Receiver Input Resistance 3 kΩ to 7 kΩ
Maximum Receiver Input Voltage �25V
Receiver Thresholds �3V

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Pinouts.ru > RS-232 and other serial ports and interfaces pinouts listing > Pinout of EIA/TIA-562 serial interface and layout of connector	Document status:	unknown
Source(s) of this and additional information: "Summary of Well Known Interface standards" by National Semiconductor	0 reports
Last updated at Sun Jun 25 2006. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
7246 hits since October 27, 2006