Cisco console port for Cisco 700 series routers pinout

serial interface

Pin	Function
1	Output--Connects to the Carrier Detect (CD) input
2	Output--Connects to the Received Data (RXD) input
3	Input--Connects to the Transmitted Data (TXD) output
4	Input--Connects to the Data Terminal Ready (DTR) output
5	Signal Ground
6	Output--Connects to the Data Set Ready (DSR) input
7	Not used
8	Not used
9	Not used

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

9 pin D-SUB male connector

Pinouts.ru > RS-232 and other serial ports and interfaces pinouts listing > Pinout of Cisco console port for Cisco 700 series routers and layout of 9 pin D-SUB female connector and 9 pin D-SUB male connector	Document status:	unknown
	0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
8493 hits since March 4, 2005