Hardware pinouts information and cables schemes

AppleLine RS232 pinout

serial interface

bookmark this page

25 pin D-SUB male connector layout

25 pin D-SUB male connector
at the computer



Pin Name Dir Description
1SNG---Shield ground
2TXD-->Tx Transmit Data, Out
3RCD<--Rx Receive Data, In
4RTS-->Request to Send, Out
5CTS<--Clear to Send, In
6DSR<--Data Set Ready, In
7GND---Ground
8DCD<--Data Carrier Detect, In
9n/c No connection
10n/c No connection
11n/c No connection
12CH<--Data signal rate selector, In
13n/c No connection
14n/c No connection
15n/c No connection
16n/c No connection
17n/c No connection
18n/c No connection
19n/c No connection
20DTR-->Terminal Ready Signal, Out
21n/c No connection
22CE<--Ring indicator, In
23n/c No connection
24n/c No connection
25n/c No connection


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > RS-232 and other serial ports and interfaces pinouts listing >  Pinout of AppleLine RS232 and layout of 25 pin D-SUB male connector
Document status: unknown
Source(s) of this and additional information: Apple Tech Info Library 1184: AppleLine Pinouts at Apple TIL homepage, from Hardware Book 1 reports
Last updated at Sat Apr 7 2007. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
10270 hits since March 4, 2005