Hardware pinouts information and cables schemes

Serial (Amiga) pinout

serial interface

bookmark this page

25 pin D-SUB male connector layout

25 pin D-SUB male connector
at the computer



Pin Name Dir Description
1SHIELD---Shield Ground
2TXD-->Transmit Data
3RXD<--Receive Data
4RTS-->Request to Send
5CTS<--Clear to Send
6DSR<--Data Set Ready
7GND---System Ground
8CD<--Carrier Detect
9+12V-->+12 Volts DC (20 mA max)
10-12V-->-12 Volts DC (20 mA max)
11AUDO-->Amiga Audio Out (Left)
12n/c-Speed Indicate
13n/c- 
14n/c- 
15n/c- 
16n/c- 
17n/c- 
18AUDI<--Amiga Audio In (Right)
19n/c- 
20DTR-->Data Terminal Ready
21n/c- 
22RI<--Ring Indicator
23n/c- 
24n/c- 
25n/c- 

Note: Direction is DTE (Computer) relative DCE (Modem).
Note: Do not connect SHIELD(1) to GND(7).


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
25 pin D-SUB female connector diagram

25 pin D-SUB female connector
at the cable

Pinouts.ru > RS-232 and other serial ports and interfaces pinouts listing >  Pinout of Serial (Amiga) and layout of 25 pin D-SUB male connector and 25 pin D-SUB female connector
Document status: unknown
Source(s) of this and additional information: Amiga 4000 User"s Guide from Commodore, from Hardware Book 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
7631 hits since March 4, 2005