Hardware pinouts information and cables schemes

DEC DLV11-J Serial pinout

serial interface

bookmark this page

Available on the DEC DLV11-J Serial card

10 pin IDC male connector layout

10 pin IDC male connector
at the Serial card (is numbering correct??)



Pin Name Dir Description
1CLK?Clock
2GND---Ground
3TXD+-->Transmit data +
4TXD--->Transmit data - (0V for RS-232, Reader enable for 20mA)
5GND---Ground
6n/c-Not connected (no pin)
7RXD-<--Receive data -
8RXD+<--Receive data +
9GND---Ground
10+12V-->+12 VDC

Note: Direction is Serial card relative other Devices.


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > RS-232 and other serial ports and interfaces pinouts listing >  Pinout of DEC DLV11-J Serial and layout of 10 pin IDC male connector
Document status: unknown
Source(s) of this and additional information: DEC DLV11-J Printset, M8043-0-1, sheet 7 and Ben Harris 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
8723 hits since March 4, 2005