HP 12/13 pin power supply connector for Vectra VL 5 minitower P-120 etc. pinout

connector or cable wiring scheme

Pin	Pin Name	Description
1	-5V	Violet - -5V 0.2A
2	-12V	Green - -12V 0.5A
3	+5V	Red - +5V
4	+5V	Red - +5V
5	+5V	Red - +5V
6	+5V_STBY	Orange - +5V Standby, seems not more than 50mA
7	+12V	Yellow - +12V
8	GND	Black
9	GND	Black
10	GND	Black
11	PWR_ON	White - Power ON from motherboard, ON=LOW (short it to GND for power on)
12	empty	pin removed, closed with a plastic plug
13	PG	Blue - Power Good to motherboard, PG=Hi

Single-in-line Molex-like 13-hole connector with one hole empty. Looking on the metal latches side of the connector, wires UP, "1st" pin is on the LEFT. PSU'S Additional 6 pin Molex 3.3V connector pinout is BLACK WIRES=GND, BROWN WIRES=+3.3V

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Pinouts.ru > ATX, BTX, WTX and other power supply cables connectors pinouts listing > Pinout of HP 12/13 pin power supply connector for Vectra VL 5 minitower P-120 etc. and layout of connector	Document status:	unknown
Contributor: Boober	0 reports
Last updated at Tue Nov 13 2007. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
974 hits since November 13, 2007