Hardware pinouts information and cables schemes

C64 Centronics Printer cable pinout

cable wiring

bookmark this page

Requires a cartridge with Centronics support (TFCIII or ActionReplay.)

UNKNOWN connector
to the C64 UserPort


C64 Dir Printer
GND1,12,A,N---19-30,33Ground
FLAG2B<--10Acknowledge
PB0C-->2Data 0
PB1D-->3Data 1
PB2E-->4Data 2
PB3F-->5Data 3
PB4H-->6Data 4
PB5J-->7Data 5
PB6K-->8Data 6
PB7L-->9Data 7
PA2M-->1Strobe
GND3-->31Initialize Printer


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
36 pin CENTRONICS male connector diagram

36 pin CENTRONICS male connector
to the Printer

Pinouts.ru > Parallel interfaces and ports cables schemes >  Pinout of C64 Centronics Printer cable and layout of connector and 36 pin CENTRONICS male connector
Document status: unknown
Source(s) of this and additional information: CBM Memorial Page Pinouts, pinout by Roy Kannady, from Hardware Book 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
7282 hits since March 4, 2005