Hardware pinouts information and cables schemes

Parallel (Olivetti M10) pinout

parallel interface

bookmark this page

Available on an old portable computer called Olivetti M10



Pin Name Dir Description
1/STROBE-->Strobe
2D0-->Data Bit 0
3D1-->Data Bit 1
4D2-->Data Bit 2
5D3-->Data Bit 3
6D4-->Data Bit 4
7D5-->Data Bit 5
8D6-->Data Bit 6
9D7-->Data Bit 7
10/ACK<--Acknowledge
11BUSY<--Busy
12PE<--Paper End
13SELIN<--Select In
14GND---Signal Ground
15GND---Signal Ground
16GND---Signal Ground
17GND---Signal Ground
18GND---Signal Ground
19GND---Signal Ground
20GND---Signal Ground
21GND---Signal Ground
22GND---Signal Ground
23GND---Signal Ground
24GND---Signal Ground
25RESETGND---Reset Ground
26/RESET<--Reset

Note: Direction is Computer relative Device.


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > Parallel interfaces pinouts listing >  Pinout of Parallel (Olivetti M10) and layout of 26 pin IDC male connector
Document status: unknown
Source(s) of this and additional information: Hardware Book, Filippo Fiani 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
6836 hits since March 4, 2005