Hardware pinouts information and cables schemes

Parallel (Amiga 1000) pinout

parallel interface

bookmark this page

25 pin D-SUB male connector layout

25 pin D-SUB male connector
at the Amiga 1000



Pin Name Dir Description
1/STROBE-->Strobe
2D0<->Data Bit 0
3D1<->Data Bit 1
4D2<->Data Bit 2
5D3<->Data Bit 3
6D4<->Data Bit 4
7D5<->Data Bit 5
8D6<->Data Bit 6
9D7<->Data Bit 7
10/ACK<--Acknowledge
11BUSY<->Busy
12POUT<->Paper Out
13SEL<->Select (Shared with RS232 RING-indicator)
14GND---Signal Ground
15GND---Signal Ground
16GND---Signal Ground
17GND---Signal Ground
18GND---Signal Ground
19GND---Signal Ground
20GND---Signal Ground
21GND---Signal Ground
22GND---Signal Ground
23+5V-->+5 Volts DC (10 mA max)
24n/c-Not connected.
25/RESET-->Reset

Note: Direction is Computer relative Peripheral.


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > Parallel interfaces pinouts listing >  Pinout of Parallel (Amiga 1000) and layout of 25 pin D-SUB male connector
Document status: unknown
Source(s) of this and additional information: Amiga 4000 User"s Guide from Commodore, from Hardware Book 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
6487 hits since March 4, 2005