Hardware pinouts information and cables schemes

PalmOne Tungsten C Headphone Jack with Microphone pinout

PDA connectors and cables

bookmark this page

4-Connector Jack on PalmOne´s Tungsten C. Speaker is Mono. Connect Micro direct to Pin 2 and 4, and also a Button in Line with a 48 Ohm Resistor.

4 pin 3.5mm (2.5mm) plug connector layout

4 pin 3.5mm (2.5mm) plug connector
at the PalmOne Tungsten C



PalmOne Tungsten C PinPin
Name		Description
1 Speaker + Earspeaker (Mono) +
2 Microphone + Microphone (and Button over 48E, and also a Diode)
3 Speaker - Earspeaker (Mono) -
4 Ground Ground, 0V


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > PDA, HandHeld computers ports pinouts >  Pinout of PalmOne Tungsten C Headphone Jack with Microphone and layout of 4 pin 3.5mm (2.5mm) plug connector
Document status: unknown

Contributor: Fritz
 0 reports
Last updated at Wed Jul 25 2007. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
1934 hits since July 26, 2007