Sony 14 pin pinout

audio or video connector or cable

14 pin SONY BETAMAX female connector layout

Pin	Signal
1	Camera video out
2	Camera video out ground
3	Camera video in
4	Camera video in ground
5	Camera pause. Shorting this pin momentarily to ground will toggle between pause and record or play mode.
6	Tally signal from the video to the camera. This causes the red light in the view finder to be displayed on the camera. It puts 5v on the pin when the video is in Record Mode, Playback, Audio Dub, x2 or Cue/Review mode.
7	Camera audio out CH-2
8	Record review. When the record review switch is pressed on the camera the video plays the last three seconds of the previous recording for monitoring.
9	Camera audio out CH-1
10	Audio ground
11	Camera audio in CH-1
12	Camera audio in CH-2
13	Camera power 12v in. Note, this is internally fused in the VCR
14	Power ground

Note: Not all machines implement all available options.

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

14 pin SONY BETAMAX male connector

Pinouts.ru > Audio / Video hardware connectors pinouts listing > Pinout of Sony 14 pin and layout of 14 pin SONY BETAMAX female connector and 14 pin SONY BETAMAX male connector	Document status:	unknown
	0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
8757 hits since March 4, 2005