Hardware pinouts information and cables schemes

SCSI-II external, Ultra SCSI (Single-ended) pinout

hard drive connector

bookmark this page

50 pin hi-density D-SUB female connector layout

50 pin hi-density D-SUB female connector
at the controller & devices



Pin Name Dir Description
1-25GND---Ground
26DB0<->Data Bus 0
27DB1<->Data Bus 1
28DB2<->Data Bus 2
29DB3<->Data Bus 3
30DB4<->Data Bus 4
31DB5<->Data Bus 5
32DB6<->Data Bus 6
33DB7<->Data Bus 7
34PARITY<->Data Parity (odd Parity)
35GND---Ground
36GND---Ground
37GND---Ground
38TMPWR<->Termination Power
39GND---Ground
40GND---Ground
41/ATN<--Attention
42n/c-Not connected
43/BSY<->Busy
44/ACK<--Acknowledge
45/RST<->Reset
46/MSG-->Message
47/SEL<->Select
48/C/D-->Control/Data
49/REQ-->Request
50/I/O-->Input/Output

Note: Direction is Device relative Bus (other Devices). Not sure about numbering. May be reversed.


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
50 pin hi-density D-SUB male connector diagram

50 pin hi-density D-SUB male connector
at the cable

Pinouts.ru > Hard drives connectors pinouts listing >  Pinout of SCSI-II external, Ultra SCSI (Single-ended) and layout of 50 pin hi-density D-SUB female connector and 50 pin hi-density D-SUB male connector
Document status: unknown
Source(s) of this and additional information: Hardware Book 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
10120 hits since March 4, 2005