Hardware pinouts information and cables schemes

Paravision SX-1 External IDE pinout

hard drive connector

bookmark this page

Paravision was formerly Microbotics.

37 pin D-SUB female connector layout

37 pin D-SUB female connector
at the controller



Pin Name Description
1/IDE-RESETDrive Reset
2D0Data bit 0
3D2Data bit 2
4D4Data bit 4
5D6Data bit 6
6GNDGround
7D8Data bit 8
8D10Data bit 10
9D12Data bit 12
10D14Data bit 14
11GNDGround
12GNDGround
13GNDGround
14GNDGround
15GNDGround
16GNDGround
17GNDGround
18+5V5V Power
19+5V5V Power
20GNDGround
21D1Data bit 1
22D3Data bit 3
23D5Data bit 5
24D7Data bit 7
25GNDGround
26D9Data bit 9
27D11Data bit 11
28D13Data bit 13
29D15Data bit 15
30/IOWI/O Write
31/IORI/O Read
32IDE-IRQInterrupt Request
33IDE-A2Address bit 2
34IDE-A1Address bit 1
35IDE-A0Address bit 0
36/BICS1Chip Select 1
37/BICS0Chip Select 0


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > Hard drives connectors pinouts listing >  Pinout of Paravision SX-1 External IDE and layout of 37 pin D-SUB female connector
Document status: unknown
Source(s) of this and additional information: SX-1 External IDE connector, usenet posting by Mike Pinso at Paravision, from Hardware Book 0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
8035 hits since March 4, 2005