ST506/412 cable pinout |
hard disks cables wiring |
34 pin IDC female connector | The ST506/412 interface requires two cables, one for control and one for data. The control cable is shared between the two drives. But each drive has each own data cable. By twisting some wires on the control cable it won"t be necessary to set the ID for each drive, since the twist will do the job. Wires 25 to 29 should be twisted between drive 1 & drive 2. Controller Drive 2 Twist Drive 1 +--+ +--+ +--+ |::|===================| |============| | <-Pin 1 |::|===================| |============| | |::|===================| |============| | |::|===================| |============| | |::|===================| |=====\/=====| | |::|===================| |=====/\=====| | |::|===================| |============| | +--+ +--+ +--+ Control cable
Data cable (To the Controller) 20 PIN IDC FEMALE to the Controller.
| 34 pin IDC female connector | |||||||||||||||||||||||||||||||||||||||
Pinouts.ru > Disk drives cables schemes listing > Pinout of ST506/412 cable and layout of 34 pin IDC female connector and 34 pin IDC female connector |
unknown | |
Source(s) of this and additional information: TheRef TechTalk, from Hardware Book, TheRef TechTalk | 0 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |