Paravision SX1 to IDE cable pinout |
hard disks cables wiring |
Can be used to connect a normal IDE harddisk to the Paravision SX1. Paravision was earlier known as Microbotics
37 pin D-SUB female connector |
Note: Pin 18+19 (+5V) can be used to power the harddisk. But most harddisks require both +5V and +12V.
| 40 pin IDC female connector | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Pinouts.ru > Disk drives cables schemes listing > Pinout of Paravision SX1 to IDE cable and layout of 37 pin D-SUB female connector and 40 pin IDC female connector |
may be incorrect | |
Source(s) of this and additional information: Hardware Book | 1 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |