IDE cable pinout |
hard disks cables wiring |
40 pin IDC female connector | The IDE interface requires only one cable. All pins straight from 1 to 1, 2 to 2 and so on. The drives can be connected in any order. Only remember that one should be jumpered as Master and the other as Slave. If only one drive is used, jumper it as Single (if such a mode exists, or most common Master else). Controller Drive 1 or 2 Drive 1 or 2 +--+ +--+ +--+ |::|===================|::|============|::| <-Pin 1 |::|===================|::|============|::| |::|===================|::|============|::| |::|===================|::|============|::| |::|===================|::|============|::| |::|===================|::|============|::| |::|===================|::|============|::| +--+ +--+ +--+
| 40 pin IDC female connector | ||||||||
Pinouts.ru > Disk drives cables schemes listing > Pinout of IDE cable and layout of 40 pin IDC female connector and 40 pin IDC female connector |
correct | |
Source(s) of this and additional information: Hardware Book | 4 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |