Floppy cable pinout |
hard disks cables wiring |
34 pin IDC female connector | The original floppy cable required that each drive was jumpered to the right ID. But IBM come up with an idea to avoid jumpering the floppies. Controller Drive 2 Twist Drive 1 +--+ +--+ +--+ |::|===================| |============| | <-Pin 1 |::|===================| |=====\/=====| | |::|===================| |=====/\=====| | |::|===================| |============| | |::|===================| |============| | |::|===================| |============| | |::|===================| |============| | +--+ +--+ +--+
| 34 pin IDC female connector | |||||||||||||||||||||||||||||||||||||||||
Pinouts.ru > Disk drives cables schemes listing > Pinout of Floppy cable and layout of 34 pin IDC female connector and 34 pin IDC female connector |
unknown | |
Source(s) of this and additional information: TheRef TechTalk, from Hardware Book | 0 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |