![]() |
ESDI cable pinout |
hard disks cables wiring |
The ESDI interface requires two cables, one for control and one for data. The control cable is shared between the two drives.
Each drive has each own data cable. By twisting some wires on the control cable it won"t be necessary to set the ID for each drive, since the twist will do the job. Wires 25 to 29 should be twisted between drive 1 & drive 2. Controller Drive 2 Twist Drive 1 +--+ +--+ +--+ |::|===================| |============| | <-Pin 1 |::|===================| |============| | |::|===================| |============| | |::|===================| |============| | |::|===================| |=====\/=====| | |::|===================| |=====/\=====| | |::|===================| |============| | +--+ +--+ +--+
Data cable
20 PIN IDC FEMALE to the Controller.
| ![]() 34 pin IDC female connector | ||||||||||||||||||||||||||||||||||||||||
Pinouts.ru > Disk drives cables schemes listing > Pinout of ESDI cable and layout of 34 pin IDC female connector and 34 pin IDC female connector |
unknown | |
Source(s) of this and additional information: TheRef TechTalk and Hardware Book, TheRef TechTalk | 0 reports | |
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |