|
ESDI cable |
������ ����������� |
The ESDI interface requires two cables, one for control and one for data. The control cable is shared between the two drives.
Each drive has each own data cable. By twisting some wires on the control cable it won"t be necessary to set the ID for each drive, since the twist will do the job. Wires 25 to 29 should be twisted between drive 1 & drive 2. Controller Drive 2 Twist Drive 1 +--+ +--+ +--+ |::|===================| |============| | <-Pin 1 |::|===================| |============| | |::|===================| |============| | |::|===================| |============| | |::|===================| |=====\/=====| | |::|===================| |=====/\=====| | |::|===================| |============| | +--+ +--+ +--+
Data cable
20 PIN IDC FEMALE to the Controller.
|  34 pin IDC female connector | ||||||||||||||||||||||||||||||||||||||||
Pinouts.ru > ������ ��� ���������� > ���������� ESDI cable ������������� ������ 34 pin IDC female � ������ 34 pin IDC female | ������ ���������: | |
| ��������(�) � �������������� ����������: TheRef TechTalk and Hardware Book, TheRef TechTalk | 0 ������� | |
Last updated at Sat Jun 25 2005 (�������� ��� ����� ��� ������ ����������) | ���� �������� �������� ������ ��� �� ����������? | |
(To the Controller)