CoStar/DYMO LabelWriter RS-232 Cable pinout

connector or cable wiring

6 pin RJ12 (6P6C) male connector
to the LabelWriter

LabelWriter Pin Name	LabelWriter Pin Number	Direction	computer Pin Number	computer Pin Name	Description
CTS	1	-->	8	CTS	Clear to send
TXD	2	<--	3	TXD	Transmit (to LabelWriter)
RXD	3	-->	2	RXD	Receive (from LabelWriter)
GND	4	---	5	GND	Ground
RTS	5	<--	7	RTS	Request to send
DSR	6	-->	6	DSR	Data set ready

This pinout comes from the cable that came with a CoStar LabelWriter XL Plus, tested with a multimeter. (It is likely that it's the same one used for other LabelWriters made by CoStar and DYMO, but this is merely speculation.)

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

9 pin D-SUB female connector
to the computer

Pinouts.ru > GPS, UPS, Switches and other devices cables and adapters schematics > Pinout of CoStar/DYMO LabelWriter RS-232 Cable and layout of 6 pin RJ12 (6P6C) male connector and 9 pin D-SUB female connector	Document status:	unknown
Contributor: Rask	0 reports
Last updated at Sat Apr 7 2007. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
3103 hits since February 27, 2007