Hardware pinouts information and cables schemes

RS-422 ADAT sync cable pinout

connector or cable wiring

bookmark this page

Alesis ADAT synchronization cable



This pinout is for a "sony" type 422 control of an alesis box, in addition to the "ADAT SYNC".
The source "ADAT SYNC" is straight through, but it is not a "422" pinout. There are four pairs of diffrering signals. Word clock, time code, control data, response data. pin 1-shields, pins 2&6 paired, pins 3&7 paired, pins 4&8 paired, pins 5&9 paired.

The interface connector is a 9-pin D-subminiature female connector. The pin assignment for the CONTROLLER and DEVICE is as shown in the following table.

Controller
Pin name
Controller
Pin
Direction Device
Pin
Device
Pin name
Description
Ground 1 1 Ground  
Receive A 2 2 Transmit A  
Transmit B 3 3 Receive B  
Transmit Common 4 4 Receive Common  
Spare 5 5 Spare  
Receive Common 6 6 Transmit Common  
Receive B 7 7 Transmit B  
Transmit A 8 8 Receive A  
Ground 9 9 Ground  


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > GPS, UPS, Switches and other devices cables and adapters schematics >  Pinout of RS-422 ADAT sync cable and layout of 9 pin D-SUB female connector and 9 pin D-SUB female connector
Document status: correct
Source(s) of this and additional information: http://www.alesis.com/downloads/manuals/ADAT-M20_RS422.pdf
Contributor: SinRoma, updated by Browning.Mccollum
2 reports
Last updated at Wed May 3 2006. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
8823 hits since February 20, 2006