RS232 to RS485 cable pinout |
interface converter |
electrically isolated RS485 communication interface to the PC serial port
EIA-485 cable usually made with twisted pair (like EIA-422) and may span up to 1200 metres. The recommended arrangement of the wires is as a connected series of point-to-point nodes, a line or bus. Ideally, the two ends of the cable will have a termination resistor connected across the two wires and two powered resistors to bias the lines apart when the lines are not being driven. The value of each termination resistor should be equal to the cable impedance (typically, 120 ohms for twisted pairs). | ||
Pinouts.ru > Convert one interface to another cables schemes listing > Pinout of RS232 to RS485 cable and layout of 9 pin D-SUB female connector |
correct | |
Source(s) of this and additional information: chaokhun.kmitl.ac.th/~kswichit/, wikipedia.org | 6 reports | |
Last updated at Fri Jun 16 2006. Submit additions or corrections for this document. | Is this document correct or incorrect? What is your opinion? |