Hardware pinouts information and cables schemes

Siemens CX75 pinout

connector or cable wiring scheme

bookmark this page

full pinout



PinPin
Name
Description
1 POWER I/O for charging the battery and for supplying external accessories by reducing standby-time
2 GROUND Digital Ground
3 TX / D+ Out for Serial-Interface, I/O for USB-Interface full-speed 12Mbis/s
4 RX / D- In for Serial-Interface, USB-Interface full-speed 12Mbis/s
5 DATA / CTS I/O Data-Line for accessory-bus, use as CTS in data-operation
6 RTS I/O use as RTS in data-operation
7 CLK / DCD I/O Clock-Line for accessory-bus, use as DTC in data-operation
8 STEREO1_OUT Analog Out, driving ext. left speaker to Pin 9 with mono-headset. Pin 8 and Pin 10 differential mode
9 PHANTOM_BUF_OUT Analog Out, mid voltage, in stereo-mode reference to Pin 8 and Pin 10, in Mono-mode not used
10 STEREO2_OUT Analog Out, driving ext. right speaker to Pin 9 with mono-headset. Pin 8 and Pin 10 differential mod
11 GND_MIC Analog In, for external microphone
12 MICEA_AC Analog In, external Microphone

Source: Original Siemens sm_CX75_M75_L2.5e_R1.0.pdf

Related Links:
Pinouts.ru > O-W (Panasonic, Samsung,...) cell phones connectors pinouts listing >  Pinout of Siemens CX75 and layout of 12 pin Siemens Slim Lumberg cell phone special connector
Document status: correct
4 reports
Last updated at Tue Jan 9 2007. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
9522 hits since December 19, 2006