Panasonic G400-600 cell phones pinout

connector or cable wiring scheme

16 pin cell phone 2 rows w/antenna left special connector layout

16 pin cell phone 2 rows w/antenna left special connector
at the mobile phone

Pin	Name	Dir	Description
16	GND	---	Ground
15	TX_Audio		?
14	AGND	---	Audio_Ground
13	HF_ON (L=ON)		L=H/F ON
12	AOP_Sense		Data Adaptor Select
11	Serial_Up		Rx UART up (9600,33.8kbps)
10	Serial_Down		Tx UART down
9	External_Power		POWER FOR CHARGING
8	Ground
7	RX_Audio
6	Radio_Mute		L=MUTE
5	HF_Sense		L=H/F MODE
4	Reserved		L=FLASH WRITE ENABLE
3	Ignition		H=ON
2	Logic_Power		H=HANDSET ON
1	PAON		Power Amplifier Control Signal

pins 3,4 must be shorted to flash

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Pinouts.ru > O-W (Panasonic, Samsung,...) cell phones connectors pinouts listing > Pinout of Panasonic G400-600 cell phones and layout of 16 pin cell phone 2 rows w/antenna left special connector	Document status:	unknown
	0 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
9634 hits since March 4, 2005