Hardware pinouts information and cables schemes

Buell ECM connector pinout

connector or cable wiring scheme

bookmark this page

for all buell XB ecm



PinPin
Name
Description
b1 +12v  
b2 Ground  
b3 Fuell pump  
b4 engine lamp  
b5 Injector front  
b6 Coil front  
b7 Coil rear  
b8 Injector rear  
b9 not connected for XB9, XB12 unknown
b10 Bank Angle Sensor  
b11 Ground for coil  
b12 Tachometer  
solo gray plug  
g1 +5 for sensors  
g2 TPS Throttle Position Sensor
g3 Camshaft position sensor  
g4 Oxygen sensor  
g5 +12 unswitched from battery
g6 Fan  
g7 Ground for sensors  
g8 Vehicle speed sensor  
g9 Engine Temperature Sensor  
g10 Intake Air Temperature sensor  
g11 Serial Recieve Data RX
g12 Serial Transmit Data TX

This is the schematics for the ECM as used on the Buell XB series

       gray                     black

 _/1  2  3  4  5  6\_        _/1  2  3  4  5  6\_


This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).
Pinouts.ru > Cars and bikes interfaces >  Pinout of Buell ECM connector and layout of connector
Document status: unknown

Contributor: Harley vd velden / Trapson
0 reports
Last updated at Wed Jul 25 2007. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
2917 hits since July 26, 2007